Yes, sensitivity at over 10x normal, so I just took 10x less. I’m taking a more normal dose now after 4 years and I believe I have become desensitized as my body normalized. Other seemingly unrelated aspects also normalized such as thyroid, testosterone, and neutrophils also improved. I was taking medication for these and have been able to stop taking them. I am assuming a lack of GLP1-As to begin with caused the receptors become more sensitive to it. When I started there was no anecdotal information available just theory, in the 4 years since many people have now had very similar experiences including hypersensitivity. (https://www.healthrising.org/blog/2025/11/03/glp-1-agonist-m...)
Most space heating is in the Northern parts though, so those are the ones that need to be addressed. There are solutions that are a pareto improvement, but it's a coordination problem and the USA is sufficiently broken and unable to solve those.
SEER, while a useful first-order approximation of efficiency, is for cooling and not heating. HSPF-V is for cold climates. Likely you just don't have a cold-climate heat pump which maintains full capacity down to -10°C (and some a little lower still), even before you get into appropriate maximum capacity.
That's not even close to correct. At the design lowest temperature (if <15°C), the very best get 2 COP, but most are 1.5 or lower. The problem is you have to accommodate the worst case.
The average of installed units is closer to 2.0 COP average, unfortunately. Multi-head units really drive down efficiency. A single-head Gree Sapphire can do 4-5 COP on average and that's the best you can get, so still nowhere near your guess.
I bet you didn't even see the tragic farce when writing your solution. Land development requiring ”2-car homes" is the driver of the problem! An apartment only has to heat one or two walls facing the outside instead of 4. That's 50-75% right off the top of your energy usage, with the mean closer to 75%.
There's nothing farcical about wanting one's own space where there's space to have one's own space. I'm grateful to no longer be sharing walls with a domestic abuse couple on one side and a midnight banshee on the other wall when she got busy. Energy is cheap, people are exhausting.
And that gets into another coordination problem we're unable to solve. It's a solved problem to build apartments where you can't hear your neighbors, but the builders don't have incentive to spend the money upfront to do so and we add regulations to make it more expensive for them to do so. So people go on thinking "apartments suck" and not the correct "we shouldn't let people build apartments which suck".
Also, living in SFH isn't avoiding all problems. I'd rather live in a properly-built apartment than my old house when my neighbor left her dogs outside to bark for the entire work day, every single day, and all the city would do is fine her a hundred bucks every few months. (or if you want to say "rural", that's 1 a small fraction of the population and 2 I like hospitals).
And the usual engineer mindset to consider the options to be 1 or 0, no?
I just live far enough from the center of it all that I have a vacant quarter acre and thicker windows that happened when the last owner's mistakes caught up with me the current owner. For medical, I have UCSF, and for major medical, I have medical tourism, something I fully endorse from experience. And yes, not everyone can do that. And well, I can't touch my toes and they probably can. Life's funny that way.
No reason to be rude or hyperbolic - I agree with you that cars destroy communities and we should strive to reduce the need for cars and parking.
For solar powered homes specifically though, multi-story buildings are much harder to run solar powered from the simple ratios - even if you reduce energy use 75%, at 4 stories you are break-even in roof-ratio-to-energy-need. I’ve worked in this space a while, and it’s now pretty straight forward to run single-family homes 24/7/367 on solar in most of the world, but multi story buildings are much harder.
Utility solar is cheaper in studies that do not factor in the cost of distribution, but the picture is much less clear when total system cost is considered - not having to pay for expanded distribution grids or new interconnects is a major benefit of residential production.
As for the last part not being true, can you clarify? The majority of the earths population lives between the 20th and 40th latitude, the band around the earth approximately between Madrid and the Sahara desert. Sure you can’t run a poorly insulated home in northern Michigan on solar year around without considerable expense, but that’s nowhere near where the majority of humanity lives.
I misread you as saying all homes. You're right that anywhere that's sunny year round, a SFH can be self-sufficient for electricity with photovoltaic and batteries.
There's a solution that costs less than fossil fuels, but it's a coordination problem and the USA is structurally unable to solve those anymore. I guess the Soviet Union wins the last laugh?
GP's argument is the marginal cost when building new is roughly that amount, not that any house can be retrofitted for that amount.
However, it's not that far off for retrofitting, if you do it when your siding already needs to be replaced. Add 3-5" XPS foam to the exterior of any standard house; if a basement you bring insulation several feet down and out below the ground. If cathedral ceiling, when replacing the roof you put 6-8" polyiso down over the sheathing before the new roofing material. If vented roof, get 1.5x code minimum blown in the attic. Air seal first, of course (1-hour of air sealing is the best ROI of anything you can do in an old house).
"Special concrete transport trucks (in-transit mixers) are made to mix concrete and transport it to the construction site. They can be charged with dry materials and water, with the mixing occurring during transport. They can also be loaded from a "central mix" plant; with this process the material has already been mixed prior to loading. The concrete mixing transport truck maintains the material's liquid state through agitation, or turning of the drum, until delivery. "
GP is partly right. Most of the cost of sewers is fixed cost: employee salaries, building and maintaining X kilometers of sewers, etc. Some is variable: chemicals, but a small part.
If you, a single person, cut your water usage in half, you pay half as much. But if everybody uses half as much, the system still needs about the same amount of funding. So now you double the per-unit price, and everybody pays the same they were before spending money on water saving features. In this case, even if each person used half as much water, the total water needed isn't cut in half because the sewers need more water to function.
(Also, water isn't "used"; most of it's transported, cleaned, transported, dirtied, cleaned again, transported)
reply